Home > Western Digital > Wd Extended Test Error 08

Wd Extended Test Error 08

Contents

Please ensure that you are not loading any other DOS level files from the floppy prior to running diagnostic utility. Replace Drive 223 Errors Repaired Errors found, but have been repaired successfully. I would not have expected that they could be so marginally different. ronnielsen1January 28th, 2011, 12:13 PMYeah, if you look to the right of the tools at: http://www.hiren.info/pages/bootcd some of them say Freeware MS Dos, some say Freeware Windows, etc. http://maxspywareremover.com/western-digital/wd-extended-test-error-code-08.php

ECC is a hardware correction technique that corrects errors. If not you will either need to get Gparted and run it from the cd to format the drive or as C_B says connect it as a slave to another PC Replace Drive If an error code is encountered that is not in the list above, please Contact Us for additional troubleshooting. If ECC occurs, use Data Lifeguard for additional error correction. look at this site

Unable To Repair Bad Sectors

I run puppy linux from a flash drive. You will probably be okay after that. Could this be linked to a bad power suply?

Use the appropriate version. Replace Drive 200 Drive Not Tested Supported WD drives are initialized with this status. However these are all "software" level solution. Western Digital Error Codes Check cabling and retest.

karthik24sOct 19, 2014, 6:55 AM Agera One said: Try what happens in other system/laptop. Test Error Code 08 Western Digital Last year there was some concern about a few stubborn bad sectors that couldn't be reallocated. Return to Top Data Lifeguard Tools 11 and 10 Error Codes Note: If the same error code is encountered more than once after re-testing, please Contact Us for additional assistance. Replace Drive 226 Sector Relocation Error Failure to relocate a sector during drive repair.

Re-Test Drive 2 SMART Attribute Over Threshold Self-Monitoring, Analysis, and Reporting Technology (SMART) threshold exceeded condition. Read Smart Attribute Command Error On Drive 2 Please contact the system vendor for the above-mentioned information. File record segment 216765 is unreadable. Error: (10/03/2014 10:13:26 AM) (Source: Microsoft Antimalware) (User: ) Description: The support for your operating system has expired.

Test Error Code 08 Western Digital

This may be due to a defect. Please re-test the drive with Data Lifeguard. Unable To Repair Bad Sectors This may be due to a media or read/write error. Smart Offline Immediately Command Error On Drive 1 Re-Test Drive If an error code is encountered that is not in the list above, please Contact Us for additional troubleshooting.

I'm afraid that you're not going to be able to fix this. his comment is here Judas, Sep 8, 2012 #9 jaydeee New Member Joined: Apr 1, 2010 Messages: 47 Likes Received: 1 Trophy Points: 0 Just wanted to share that I use chkdsk /r to fix SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Try these and see whether the files gets copied fully, otherwise corrupted. Western Digital Quick Drive Test Failed

So no luck for a repair install. Retest and replace the drive if the error repeats. Nitrozzy7January 24th, 2011, 07:50 AMDo you know if it's possible to save the disk? http://maxspywareremover.com/western-digital/western-digital-extended-test-error-08.php Replace Drive 209 Previous Error Code not found Data Lifeguard Diag could not determine a previous error code.

If you do a 3 Pass wipe and the SMART is good go for it. Status Code 07 Failure Checkpoint 97 It also may be due to a defective connection. The drive is still bad and could get sevearly worse over either a long or extremely short period of time.

Re-Test Drive 102 Seek Timeout A Seek command did not complete in the time allotted for its completion.

Running %%860 on an out of support operating system is not an adequate solution to protect against threats. If the above theory stand still as true, in that case it is applicable for all media read devices right ?So only asked if anything is missing from technical perspective which Replace the drive if the error repeats. Western Digital Bad Sector Repair Darik's Boot and Nuke (DBAN) 1.0.7 Completely deletes the contents of any hard disk it can detect.

Replace your cable and retest the drive. The elapsed time is absolutely wrong. Replace Drive 226 Sector Relocation Error Failure to relocate a sector during drive repair. http://maxspywareremover.com/western-digital/western-digital-extended-test-error-code-08.php Drive should be replaced.

Pages of WD's with a scattering of Seagate and/or other brands. Transparent Auto RElocate. Replace drive if unable to correct error 120 NO DRIVE FOUND Cannot communicate with drive. Re-test Drive 136 Bad Sector Sector Marked Bad Error.

Thanks a bunch for all who replied and helped here in this thread. Thunx again! Replace the drive if the error repeats. Ensure that you are using the latest version of diagnostic utility and that your cable is in good working condition.

This may be an anomaly. Non-WD drives are not supported. But it is dying and it will die and any info you put on it is at high risk.