Home > Western Digital > Western Digital Error 0225

Western Digital Error 0225

If the automatic repair feature is unable to repair these errors, replace the drive. James Back to top #8 anonanon anonanon Topic Starter Members 141 posts OFFLINE Gender:Male Local time:04:24 AM Posted 03 March 2013 - 08:45 PM Thanks, I'll run chkdisk on it Replace the drive if the error repeats. Re-Test Drive 9 Write Sector Failure A write command during the test has failed. weblink

Has anyone experienced this before? Replace the drive. This may be due to a defect with the drive or a bad connection. Auto Offline data collection on/off support. their explanation

Although I don't know what the Rubber Manufacturers Association has to do with it but then again who am I to question your methods? · actions · 2011-Jun-7 9:25 pm · Re-Test Drive 8 Read Sector Failure A Read command during the test has failed. Drive should be replaced. James Back to top #6 anonanon anonanon Topic Starter Members 141 posts OFFLINE Gender:Male Local time:04:24 AM Posted 27 February 2013 - 11:29 PM James, Sorry for the delay,

How do I make the Seagate PATA the master drive and the WD SATA the slave drive? http://www.bleepingcomputer.com/forums/t/2520/how-did-i-get-infected/Forum Rules, The BC Welcome Guide 167 @ June 2015 Back to top #4 anonanon anonanon Topic Starter Members 141 posts OFFLINE Gender:Male Local time:04:24 AM Posted 16 February 2013 Running %%860 on an out of support operating system is not an adequate solution to protect against threats. Please ensure that you are using the proper version of diagnostic utility.

An error was reported by the drive during the Write command (to cause the auto-relocation) or the Read Verify command (to verify the relocation happened). Replace the drive if the error repeats. Conveyance self-test routine recommended polling time: ( 5) minutes. here Western Digital External drive Western Digital has done it again!!!

I highly recommend you do the Advanced Replacement method, since WD sends you a completely different disk *in advance* (you have 30 days to send your bad one to them). On one HD, I have done ZERO write via DOS with DLGDIAG 5.2 Formatted with WIN 7 (on an SSD) in GPT and NTFS, copied 2TB. Check cabling and retest. Re-test Drive 138 Still Busy Timeout Timeout from checking busy bit.

Are suitable to be used as Backup drive, Switched on twice/day for 2 hour and the switch off? http://forum.overclock3d.net/showthread.php?t=42603 Trying a different non-WD HDD to see if I get the same problems (and if I do, it's probably a setting in BIOS I need to change, ie. Back to top #5 James Litten James Litten Ԁǝǝ˥q BC Advisor 1,928 posts OFFLINE Gender:Male Location:New Jersey Local time:04:24 AM Posted 16 February 2013 - 03:24 PM Hi It ECC is a hardware correction technique that corrects errors.

Replace the drive if the error repeats. have a peek at these guys Western Digital warranty on ATA-100 250G HD Can't Assign Drive Letter to slave drive Western Digital and Hard Drive spin-down Thought on Western Digital HD I have a western digital 320g There may be media errors present on this drive. to report if a drive has failed, it must be enabled as a system option.

Re-Test Drive 17 Erase SSD Failure A write command during the test has failed. You will probably be okay after that. Replace the drive. check over here lakedude Golden Member Joined: Mar 14, 2009 Messages: 1,621 Likes Received: 1 Got an old system that had a bad MB so I replaced the MB with a new one.

Replace the drive if the error repeats. Error logging capability: (0x01) Error logging supported. If Selective self-test is pending on power-up, resume after 0 minute delay.

Offline surface scan supported.

Replace the drive if the error repeats. Re-Test Drive 19 SMART Enabled Operation Failure Self-Monitoring, Analysis, and Reporting Technology (SMART) Enable Operation failed. This may be due to a media error. Selective Self-test supported.

The chkdsk report will say found 4k in bad clusters. Just PM me how much you want and will exchange info.Absolutely no need to pay me -- I enjoy helping users of the BBR/DSLR community, and I'd rather spare hardware I Apr 25, 2008 #1 Rakinos [H]ard|Gawd Messages: 1,520 Joined: Jul 31, 2001 So I'm trying to fix a computer, that "stopped working" (endless reboot loop @ windows loading screen) when the http://maxspywareremover.com/western-digital/western-digital-hard-drive-error-0225.php If the errors continue, replace the drive.

Re-Test Drive 7 SMART Offline Immediate Command Failure Self-Monitoring, Analysis, and Reporting Technology (SMART) Offline Immediate command failed. Computers with S.M.A.R.T. Several instances of information on data positioning and location could not be found. Create and use a new DLG Tools diskette.

CONTRIBUTE TO OUR LEGAL DEFENSE All unused funds will be donated to the Electronic Frontier Foundation (EFF). It also may be due to a defective connection. Report back. Absolutely unacceptable. (I understand why -- Acronis wants to believe "people don't need to know what's going on under the hood", but in this case knowing what's going on under the

I tried changing the jumpers on the PATA drive but still I get the black screen. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Roger ____________________________ MiniToolBox by Farbar Version: 21-07-2014 Ran by RK (administrator) on 04-10-2014 at 18:37:46 Running from "F:\Documents and Settings\RK\My Documents\Downloads" Microsoft Windows XP Professional Service Pack 3 (X86) Error: (10/04/2014 09:54:43 AM) (Source: Microsoft Antimalware) (User: ) Description: The support for your operating system has expired.

After the disk check Gparted still refused to clone the partition claiming errors once again.