Home > Western Digital > Western Digital Error Code 007

Western Digital Error Code 007

There were too many errors found on this drive to be repaired. Replace the drive if the error repeats. This is the pretest initialization code which indicates a drive is ready to be tested, but has not yet been tested. Replace Drive 219 Drive Cable Error Failure during cable test. weblink

If the error repeats, replace the drive. Create and use a new DLG Tools diskette. Hit any key to retry', plus it gives a 'bad sector' error, in Windows, frequently. Several instances of information on data positioning and location could not be found.

Re-Test Drive 102 Seek Timeout A Seek command did not complete in the time allotted for its completion. Drive should be replaced. Use the appropriate version.

If the automatic repair feature is unable to repair these errors, replace the drive. Computers with S.M.A.R.T. Check cabling and retest. Drive should be replaced.

Also, which test should I select, the quick or the extended one? It may also happen when the wrong version of diagnostic utility is used. Direct downloads are not allowed. Get More Info Are there only parts of the disk that have gone bad and how does this happen?

This may be due to a media error. Re-Test Drive 9 Write Sector Failure A write command during the test has failed. A bus station is where a bus stops. The drive has to be replaced.

Please ensure that you are using the version of diagnostic utility corresponding to either newer or older Western Digital drives. get redirected here The automatic repair feature can attempt a repair if possible. Drive should be replaced. Check your connections and replace the cable.

This may be due to a media error. have a peek at these guys It also may be due to a defective connection. It is also possible to see this error on defective Western Digital drives. Retest after checking the connections.

There were media errors that were within the repair capabilities of diagnostic utility. Re-test Drive 139 DRQ NOT EXPECTED The drive did not properly respond to test commands. Recheck your connections and replace the cable. check over here There is no error now, but I have a advance replacement ordered.

The drive has to be replaced. This may be due to a defect with the drive or the drive may not have responded properly due to a bad connection. Re-Test Drive 586 DRQ Timeout Data ReQuest Timeout.

All the studios want is more money & control.

Re-test Drive 135 DRQ Timeout Timeout from checking Data ReQuest Timeout (DRQ) bit. It is possible the WD drive is more 'picky' on the power, either voltage or amps? Replace the drive. Any kind of help would be appreciated.

The information file, which holds the data pertaining to this drive, is corrupted or missing. This may be due to a defect with the drive or the drive may not have responded properly due to a bad connection. Replace the drive if the error repeats. http://maxspywareremover.com/western-digital/western-digital-error-code-120.php And yes, at times, the BIOS fails to detect the drive, and that's when I get the 'No boot device detected.

An error was reported by the drive during the Write command (to cause the auto-relocation) or the Read Verify command (to verify the relocation happened). Self-Monitoring, Analysis, and Reporting Technology (SMART). CPU Failure? Re-Test Drive 257 ECC 2-9 Error Correction Code.