Home > Western Digital > Western Digital Error Codes

Western Digital Error Codes

Contents

There could be media errors present on this drive. The drive has failed and must be replaced. Re-test Drive 136 Bad Sector Sector Marked Bad Error. Several instances of information on data positioning and location could not be found. weblink

Your cache administrator is webmaster. Please ensure that you are not loading any other DOS level files from the floppy prior to running diagnostic utility. Replace the drive if the error repeats. The drive is defect free. internet

Western Digital Error Code 0007

This may be due to a defect with the drive or a bad connection. Re-test Drive with appropriate diagnostic utility 133 Illegal ID FW overlay not found. Check your floppy and retest. Family and loved ones will always be a priority in my daily life.

Re-test Drive 145 FULL STROKE ERROR Error encountered during full stroke seek. There may be media errors present on this drive. This may be an anomaly or a defect with the drive. During idle periods, an off-line scan could be performed to scan the entire media of the hard drive.

It also may be due to a defective connection. error: If a problem is encountered, you can use Data Lifeguard Diagnostic for DOS (floppy) or a Data Lifeguard Diagnostics for DOS to perform a more detailed analysis of the hard Replace drive if unable to correct error 120 Unknown Error An unknown error has occurred during testing. click site If the error repeats, replace the drive.

Replace the drive if the error repeats. Re-Test Drive 18 Read Verify Sector Ext Error A Read Verify Sector Ext command during the test has failed. Replace the drive if the error repeats. All rights reserved.

Data Lifeguard Diagnostic For Dos

Retest after checking connections. Use the appropriate version. Western Digital Error Code 0007 Check cabling and retest. Western Digital Support You may need to rescan to ensure that the repairs were effective.

Replace. http://maxspywareremover.com/western-digital/western-digital-error-codes-0201.php Drive should be replaced. All postings and use of the content on this site are subject to the Apple Support Communities Terms of Use. Re-Test Drive If an error code is encountered that is not in the list above, please Contact Us for additional troubleshooting.

Further errors indicate a defective drive. One instance of information on data positioning and location could not be found. Drive should be replaced. check over here Retest after checking the connections.

SMART III: Not defined by any industry standard specification. Re-test Drive 137 Relocated Sector Sector Relocated. Trying a different non-WD HDD to see if I get the same problems (and if I do, it's probably a setting in BIOS I need to change, ie.

oxter 2011-08-08 12:47:11 UTC #4 What RMA you did?

This may be a drive issue, however it may be related to a defective connection. Replace the drive if the error repeats. Drive should be replaced. If the error repeats, replace the drive.

SERVO is data on track location. Check cabling & retest. Re-Test Drive 107 Check Sum Error Accumulated test data on the drives is corrupted. this content Re-test Drive 206 Memory Allocation Error Unable to allocate memory for program structures.

If the error repeats, replace the drive. Several instances of information on data positioning and location could not be found. Replace Drive 200 Drive Not Tested Supported WD drives are initialized with this status. Replace the drive if the error repeats.

This may be due to a defect with the drive or the drive may not have responded properly due to a bad connection. This may be due to a defect. Re-Test Drive 104 Drive Not Ready The drive did not properly respond to test commands. The drive may not have been accessed properly possibly due to a bad connection.

Please ensure that you are using the version of diagnostic utility corresponding to either newer or older Western Digital drives. A number of ECC errors (between 2 through 9) have been detected. Replace Drive If an error code is encountered that is not in the list above, please Contact Us for additional troubleshooting. No way.

Retest after checking the connections. Check cabling and retest.