Home > Western Digital > Western Digital Error Status Code 0201

Western Digital Error Status Code 0201

Replace the drive if the error repeats. Please report the number of HD's and the manufacturer name. 05-04-2007, 08:53 PM #5 Girderman Registered User Join Date: Oct 2006 Posts: 2,148 OS: XP Pro Whatever happened or it's affiliates. Please re-test the drive with Data Lifeguard. http://maxspywareremover.com/western-digital/western-digital-error-codes-0201.php

Check cable and retest. It also may be due to a defective connection. Replace the drive. If the drive is recognized there, than something is likely wrong with either your power supply, or the data port (or BUS) your drive is being connected to 7. https://support.wdc.com/knowledgebase/answer.aspx?ID=11711

Replace Drive 209 Previous Error Code not found Data Lifeguard Diag could not determine a previous error code. Your post is rather sparse in detail. Replace the drive if the error repeats.

Retest after checking the connections. Re-test Drive 163 Unknown Error Queued command timed out. Please follow the instructions below on troubleshooting this issue: 1. Several instances of information on data positioning and location could not be found.

Replace Drive 211 Self Test Never Completed The drives internal self-test could not complete due to unrepairable errors. Re-test Drive 136 Bad Sector Sector Marked Bad Error. Privacy Policy Terms of Use Trademarks Select your Language Language 中文(繁體) 中文(简体) Čeština Deutsch English Español Francais ελληνικά Italiano 日本語 한국어 Polski Português РУССКИЙ Türk Return to WDC.com WD Community Contact http://www.techsupportforum.com/forums/f10/non-wd-drive-error-code-0201-a-151888.html This may be due to a defect.

Drive should be replaced. Replace Drive 585 Busy Timeout During a read verify, a command could not be completed. This error is most likely an internal malfunction of the drive and not related to the condition of the cables etc. You may need to rescan to ensure that the repairs were effective.

Replace the drive if the error repeats. http://forums.hexus.net/help-quick-relief-tech-headaches/153077-problems-booting-new-hd.html This may be due to a media or read/write error. Check cabling and retest. Check cabling and retest.

Re-Test Drive 112 IRQ Timeout Interrupt ReQuest Interrupt signal not received. have a peek at these guys Check Floppy and use appropriate diagnostic utility 209 Self Test Failed To Run SMART Self Test failed to start when executed. This may be due to a media or read error. When i boot up this weird information comes up and then at the bottom, written in blue it says Non-WD Drive Error/Status Code 0201 Remove Advertisements Sponsored Links TechSupportForum.com Advertisement

Check connections and retest. It also may be due to a defective connection. At least ten errors have been detected. http://maxspywareremover.com/western-digital/western-digital-error-status-code-007.php At least ten ECC errors have been detected.

Replace your cable and retest the drive. Check cabling & retest. The information file, which holds the data pertaining to this drive, is corrupted or missing.

Check cabling and retest.

May need to run DLGUDMA to set the drive to a slower speed or replace the IDE cable. DIY Perks 3.456.226 visualizaciones 10:28 Recover Data HHD hard drive from broken external Western Digital mybook enclosure repair solution - Duración: 13:01. If it is an internal drive make sure the SATA or PATA (EIDE) cable is securely attached to both the drive, and the controller card. There were too many errors found on this drive to be repaired.

Return to WDC.com WD Community Contact Us English Product Support My CloudMy BookMy PassportWD Elements & WD TVInternal DrivesWDLabsLegacy & Other Products Downloads WD Software Product Firmware Product Downloads Warranty & WDC Support Downloads Knowledge Base Product Registration Warranty Services Contact Ask a Question Contact Support Feedback Other Sites MyCloud.com Online Learning Center CONNECT WD Blog © 2016 Western Digital Technologies, Inc. Check cabling & retest. this content This may be an anomaly or a defect with the drive.